RHADOX 7100 / 7100 Ex

To allow the economic use of Off-gases from processes a reliable control of the burners requires Wobbe-Index and Air demand as control values, to adjust to the ever changing gas composition. These two parameters are measured with the RHADOX 7100 / 7100 Ex Analyser.

Typical applications are:

  • Off-gases from blast furnaces
  • Off-gases from chemical and petrochemical plants
  • Off-gases from water treatment plants and biomass plants
  • Quality control in the glass industries
RHADOX 7100

Due to the deviation in quality of Off-gases the RHADOX™ Analysers are calibrated with two gases which represent the low and high end of the measuring range. The accuracy of the measurement is depending mostly on the simulation of the Off-gas by the calibration gases. The definition of the calibration gases is provided by AMS. The quality of the calibration gases is most important.

To take advantage of the extremely fast response and T90-times the RHADOX™ Analysers have to be installed close to the point of gas extraction. The only prerequisite is a frost-free environment at the point of installation.

The RHADOX™ Analysers are mounted on a metal mounting plate with the components catalytic reactor, gas mixing chamber, electronic evaluation unit, power supply and measuring signal distribution installed in separated sheet metal housings. The housings of the components are manufactured for general purpose in protection class IP 65.


Technical data

Measuring System RHADOX 7100 / 7100 Ex
Ex-classification ATEX II 2G Ex px IIB+H2 T4 Gb X (Ex-Zone 1)
ATEX II 3G IIB+H2 T3 (Ex-Zone 2)
Measuring components / -ranges  
Air demand smallest measuring span 1,5 m3 Air / m3 Gas
largest measuring span 30 m3 Air / m3 Gas
Wobbe-Index smallest measuring span 5 MJ / m3
largest measuring span 120 MJ / m3
Analogue output port 2* 4 … 20 mA, galvanically separated
Reproducability 0,15 % of measuring value
Long term drift < 2 % of measuring value / month
Temperature drift < 0,02 % / K, relative to end of measuring range
T90-Time ca. 5…15 seconds, depending on viscosity of the measuring gas
Other data  
Display 2* 16 digit illuminated LCD display
shows Wobbe index, air demand and analyser status
Optional graphic screen
Messages 1 System message (Measuring value yes / no)
3 Messages (Indication of operating status)
Service, Calibration, Error messages
Digital communication Serial interface RS232
Optional interface RS 485, Ethernet
Ambient operating temperature from - 5 °C to + 45 °C
Operating temperature from + 5 °C to + 60 °C,
Special version up to + 105 °C
Gas connections  
Inlet Calibration gas 3 mm, Mesuring gas , Instrument Air 6 mm, Ferrule pack
Outlet Gas outlet 12 mm, Bypass 6 mm Ferrule pack
Gas flow volume Measuring gas 20 … 100 Nl/h
Instrument Air 50 … 500 Nl/h (depending on Air demand)
Gas pressure (at Inlet) > 0,1 bar (g)
Instrument Air > 2 bar (g), max. 8 bar (g)
Power supply 115 or 230 VAC / 50 - 60 Hz, 1000 VA
Protection class / Housing IP65
Dimensions 1000 x 900 x 350 mm (hxbxt)
Weight ca. 100 kg … 140 kg, depending on protection class
Options integrated catalytic by-pass-gas remover
Auto-Calibration
Version: AMS RH7100 E V-2013-07