AMS 5100 Z

The basics of the Oxygen Analyser AMS 5100 Z is the development project "AMS 5000". The Trace Oxygen Analyser AMS 5100 Z is designed for the measurement of the lowest Oxygen traces under presence of oxidable components for example in Air separation plants. For this application the Oxygen Analyser AMS 5100 Z is equipped with a catalytic inactive Zircondioxid sensor. Due to the compact design the Oxygen Analyser AMS 5100 Z is available in different housing types.

A long list of options allows to adopt the Oxygen Analyser AMS 5100 Z for almost every application. The software for remote control and remote service with access via the customer computer network further increase the flexibility of the Oxygen Analyser AMS 5100 Z in an application.

AMS 5100

Technical data

Analyser AMS 5100
Measuring principle Catalytic inactive ZrO2 probe
Application Gases Industries, Chemical Industries
Measuring range 0 … 25 Vol %
0 … 10 ppmv
Analogue signal port (0) 4…20 mA or 0…10V, galvanically separated
Reproducability +/- 2 % of the measuring value
Resolution 0,01 ppm – C(O2) – 0,01 %
depending on the O2 concentration
T90-Time < 20 seconds
Display 2* 16 digit, illuminated LCD display
1. Line: display of concentration in ppm or Vol %
2. Line: Messages, device status, sensor parameters
Messages 1 System message (measuring value yes / no)
max. 1 message configurable as oxygen value,
calibration message, measuring value in the range, flow
Gas connection inlet / outlet 3 / 6 mm ferrule pack
Gas sampling built-in inlet / outlet valve
Sample flow min. 20 Nl/h, max. 40 Nl/h
sample pressure (inlet) min. 1,1 bar abs., max. 2 bar abs.
Digital communication serial interface RS232
Ambient operating temp. + 5 °C up to + 60 °C
Power supply 110 … 230 VAC or 24 VDC
Protection / Housing / Dimensions IP20 / electronics unit, 1/2 inch, 19 inch / 3HU
IP65 / wall mounting housing / ca. 327 x 270 x 326 mm (hxbxt)
IP54 / portable housing 42 TE / 3 HU
Weight 2,5 kg … 10 kg depending housing and built-in options
Options Pneumatic pump
Electronic flow control
Software for remote control and service
Particle filter 2–7 µm
Pressure regulator
Version: AMS 5100 Z E V-2019-06  

Oxygen measurement

Please note: The cross interference from combustible gases to the Oxygen measurement depends upon the temperature, the gas flow rate and both the concentration of Oxygen and of the combustible component.

Oxygen concentration 10 ppmV O2 100 ppmV O2
Combustibles Cross interference Cross interference
10 ppm H2 < -0,5 ppm O2 < -1 ppm O2
10 ppm CO < -0,4 ppm O2 < -0,6 ppm O2
1000 ppm CH2 not traceable < -1 ppm O2